EMERSON WHITE RODGERS...
Master Relay (Battery Solenoid) for all homebuilts (not suitable for certified aircraft). Continuous duty. Offered for 12V and 24V systems.
Fine quality switch from ACS used in many aircraft. The switch housing is machined from billet aluminum which makes this switch 25% lighter. It provides “ON” and “OFF” electrical control of both magnetos on a single engine aircraft. The key-operated switch mounts from the rear of the panel in a 7/8” dia hole. Available with or without starter position. A-510-2 model with starter position is supplied with switch plate two keys. (diode included). FAA PMA Approved. Made in USA.
Master Relay (Battery Solenoid) for all homebuilts (not suitable for certified aircraft). Continuous duty. Offered for 12V and 24V systems.
BC207 High/Low Voltage Warning Indicator by B&C SPECIALITY PRODUCTS is a solid-state device which provides a visual indication of abnormal bus voltage via a panel-mounted warning light (included). It is intended for use in non certified aircraft. Not FAA Approved. When flashing,the warning light indicates a bus voltage greater than 15.5 volts D.C. When steady, it indicates a bus voltage below 12.5 volts D.C. The product also includes B&C S708-2 Miniature Push-Button switch (push-to-test). The BC207 Voltage Warning Indicator can be used in both 14v and 28v electrical systems.
Bi-metallic single toggle thermal circuit breakers suitable for homebuilt aircraft. Used as original equipment in Beech, Cessna and Piper aircraft. 0.5 amp to 50 amp ratings may be used as on/off switch. Maximum operating voltages: 32 VDC and 250 VAC (to 400 Hz).
Product Features:
Lightweight, less than 2 oz.
0.5 amp to 50 amp ratings may be used as on/off switch.
Cannot be reset against overload.
Screw termination.
Trip-free operation.
FAA-PMA Approved original equipment TCM Bendix magneto ignition switches with 3 positions (Right/Left/Both Mags). They come complete with two keys and faceplate. For dual ignition aircraft systems, ignition switch grounds both magneto P-leads in off position.
EMAS MA Series toggle switches feature maximum product reliability with V0 material and are offered in different contact and badge options.
NOTE: This product is no longer available. Limited quantities may be offered from existing stocks of different vendors.
ROTAX® aircraft engines form part of the product portfolio of BRP-Powertrain GmbH & Co. KG which develops and manufactures engines for snowmobiles, watercrafts, boats, roadsters, all-terrain and side-by-side vehicles, motorcycles, carts, and aircrafts.
BRP-ROTAX® product range includes certified and non certified internal combustion engines, parts and accessories for light and ultralight aircraft.
Different alternators are used in BRP-ROTAX® aircraft engines. They are offered as certified or non certified parts from the manufacturer. Non certified parts can be used in ultralights or other aircraft not requiring certification of parts for their installation. Certified parts are designated by the letters "CERT" after the part number in the product reference number (SKU).
Aircraft engine parts are subject to changes from time to time. Some parts may be no longer available or replaced by others with different part numbers. Listed BRP-ROTAX® engine parts do not imply their current availability or suitability for your engine application. Always consult the most recent Illustrated Part Catalogs (IPCs) or other documentation available from the manufacturer for the correct part number before ordering.
Versatile split red master switch used in virtually all single engine Cessna models since 1970. It can be used in most light aircraft with single alternator systems. Left rocker normally is used for alternator and right half for battery. Amp Rating: 20. The swich housing mount (P/N: S1843-1) is sold separately and can only be ordered together with the switch.
Slick magnetos by CHAMPION AEROSPACE are used on nearly all aircraft piston engines. They exhibit distinct design and operational features outlined below ensuring improved performance and service life.
Smaller and lighter unique design
Radio noise suppression
Lift-off housing
Easy to maintain
OEM Approved for more than 225,000 aviation engines
Service at 500-hour intervals (*)
CHAMPION AEROSPACE Slick magnetos are offered in NEW or FACTORY OVERHAULED condition (**) in a broad range of options. Both can be supplied as exchange units to returned cores and include genuine OEM parts produced and inspected under rigorous procedures to ensure airworthiness and suitability in Slick magnetos. The factory overhauled magnetos are sourced by CHAMPION AEROSPACE authorized overhauling stations and adhere to strict CHAMPION AEROSPACE restrictions on the use of parts and service literature.
For additional information please refer to the Product Description section and the supplied documentation.
(*) In accordance with CHAMPION AEROSPACE Overhaul Manual L-1363F, the magneto should be overhauled at TBO, lightning strike, prop strike, sudden stoppage of the engine and immersion of the aircraft.
(**) NEW EXCHANGE or FACTORY OVERHAULED EXCHAGE Slick magnetos are offered in exchange of an existing customer owned unit (core) for a quick turn around. A refundable core charge is included in the selling price. This is refunded or credited towards future orders with us when a qualified core is returned and its condition is approved by our co-operating supplier within 60 days of the date of the purchase invoice. As a general rule, approvals of core returns for FACTORY OVERHAULED Slick magnetos are granted to cores of the current series of these magnetos while for NEW EXCHANGE Slick Magnetos, cores of older series of Slick magnetos can be considered for credit on a case by case basis. In all cases, the approval of a returned core remains at the exclusive discretion of our co-operating supplier and shipping back to the customer of non-approved cores are subject to additional charges.
YAESU rechargable batteries are intended for use with YAESU handheld transceivers.
The KLIXON® PS series 2 to 35 Amp precision thermal circuit breakers by SENSATA TECHNOLOGIES Inc. (formerly Texas Instruments Sensors & Controls) are designed to interrupt short circuits or overloads and combines trip-free protection with fast response time. They feature a bi-metallic snap-acting disc as the sensing element and they are widely used in production and military aircraft where precise ultimate trip characteristics are required. Models PSM and PSM-N are available in the following ampere ratings 2, 3, 5, 10, 15, 20, 25, 35. When ordering specify if neck-mounting style is wanted by placing “N” after ampere rating. Example: PSM-10N
The KLIXON® PDL series thermal breakers are designed to meet the harshest environmental requirements. They are weatherproof for protection against moisture, dust, grease, fuel vapors, and other harsh environments. For weatherproof circuit breakers in ratings from 50 to 150 amperes, order Model PDLM.
Aviation grade ELECTRODELTA X61 series solenoids by LAMAR TECHNOLOGIES LLC are offered in continuous or intermitant duty in 12 or 24 Volt. They fit current GA production aircraft as well as legacy aircraft and replace both single terminal switched units, as well as the current double terminal switched units in production today. All units have multiple quality and functional tests prior to certification and delivery. Non FAA-PMA Approved.
Product Features:
Replace most contactors in general aviation
Available in 12 or 24 Volt
Available for Continuous or Intermittent duty
All units inspected and tested to performance standards
Warranty 24 months
Elevate your aviation experience with Textron Aviation, your trusted source for top-tier aircraft batteries. CONCORDE® BATTERY CORPORATION, is a leader in high-quality lead-acid batteries, to power Cessna®, Beechcraft® and Hawker® aircraft. Their PLATINUM family of batteries offer superior engine starting performance, excellent charge acceptance, reliable essential power in the event of a generator failure, maintenance-free operation with no need for electrolyte or water addition, and advanced absorbed glass mat (AGM) separators. CONCORDE® PLATINUM batteries are hazmat exempt and shipped fully charged and ready to install.
The CONCORDE® RG® Series of premium hand made AGM aircraft batteries within the PLATINUM family are low resistance, valve regulated lead acid (VRLA) batteries providing excess power for many applications. The RG-25XC aircraft battery has the highest cranking power and capacity in the 25 Group.
Since its introduction in 1994, the B&C SPECIALITY PRODUCTS BC320 Starter for Continental engines has established an impressive service record as the ONLY starter design on the market that has provided reliable, long-term service for these engines.
Suitable for installation on Continental engines (C-75, C-85, C-90, C-145-2, O-200, IO-240, O-300-A, -B, and -C, and GO-300-A, -B, and -C) it solves all the problems that other starter designs have had: worn-out clutches, broken pinions, nagging oil leaks, and catastrophic failure modes. Featuring the durability of all-steel gears and heavy-duty ball-bearings, and the efficiency of a high-torque series-wound motor, it provides greater starting torque, while saving 4.3 to 5.2 lbs. over the old key-type and pull-cable type starters (respectively).
The B&C SPECIALITY PRODUCTS BC320 Starter is STC-PMA approved for use in certificated aircraft, and is available with or without the STC (*). Two installation kits are also available: one for replacing a key-type starter (Installation Kit 501-1), the other for replacing a pull-cable type starter (Installation Kit 501-3). For key-type starters, before installing the BC320, you will need to remove the needle bearing pressed into the engine case & install the supplied plug in its place. For pull-cable starters, before installing the BC320, you will need to cut off the 9/16 steel shaft that is installed in your engine case.
Other versions of BC320 Starter for 12v and 24v electrical systems (BC320-2, 12v Counter-Rotating or the 24v BC320-3) are also available.
(*) For the issue of the STC, the aircraft make and model, aircraft registration and serial number are required.
ROTAX® aircraft engines form part of the product portfolio of BRP-Powertrain GmbH & Co. KG which develops and manufactures engines for snowmobiles, watercrafts, boats, roadsters, all-terrain and side-by-side vehicles, motorcycles, carts, and aircrafts.
BRP-ROTAX® product range includes certified and non certified internal combustion engines, parts and accessories for light and ultralight aircraft.
Different starter relay assemblies are used in BRP-ROTAX® aircraft engines. They are offered as certified or non certified parts from the manufacturer. Non certified parts can be used in ultralights or other aircraft not requiring certification of parts for their installation. Certified parts are designated by the letters "CERT" after the part number in the product reference number (SKU).
Aircraft engine parts are subject to changes from time to time. Some parts may be no longer available or replaced by others with different part numbers. Listed BRP-ROTAX® engine parts do not imply their current availability or suitability for your engine application. Always consult the most recent Illustrated Part Catalogs (IPCs) or other documentation available from the manufacturer for the correct part number before ordering.
Military Specification MS35059 Series Toggle Switches can be used to upgrade your aircraft's cockpit controls. These heavy-duty metal switches have a standard shape that works well for a variety of applications can be used for most components that only function in either the on or off positions. They are available in several sizes to fit your particular airplane and are shipped with all necessary rings and hardware for installation. Toggle switches are available with two or three operating positions, 1 or 3 hole mounting and a variety of circuitry & electrical ratings. Contacts are made of solid silver. Wide usage is found in aircraft, mobile, marine, electronic and industrial applications. Available in full "AN" standard size & Ultra Miniature 1/2" size, contact types and circuit codes (see reference chart).
RED BOX® AVIATION, part of the LPA Group, offers a comprehensive range of aircraft ground power equipment including ground power units, aircraft start power units, aircraft connectors and more.Their ground power range or aircraft GPU, are designed for the civilian and military markets, while the majority of their products are also NATO codified.
RED BOX® AVIATION aircraft hand portable start power units (packs) are included among the most powerful hand portable packs worldwide. they are based on military aerospace technology to achieve a very high power to weight ratio. These power packs are designed for starting of piston, turboprop or turbine aircraft and helicopters in the field or in remote locations while RED BOX® units may also be carried safely on board all aircraft. The power packs are “all weather” units and being modular, can be used in single or dual format. They can be used or stored in any orientation, even inverted. Cells used are cleared as non-hazardous cargo for carriage in the aircraft. They are able to operate in extremes of temperature and have excellent standby characteristics. They are maintenance free and do not require cycling. They can be re-celled “on condition” at any RED BOX® service center and are designed to offer years of repeated service. In addition to aviation, these highly portable units can be used with Armored Fighting vehicles and Military equipment. They can be recharged from the automatic charging system, which is supplied in the package, or from any vehicle using a suitable interface.
Product Features:
Offered models in different voltages and amperages
Totally weather protected
Air transportable
Non-hazardous
Maintenance Free
Tough and compact
No memory effect
Works in any orientation
High charge retention
Long shelf life
Fast recharge
No cycling
Leak proof
Fine quality switch from ACS used in many aircraft. The switch housing is machined from billet aluminum which makes this switch 25% lighter. It provides “ON” and “OFF” electrical control of both magnetos on a single engine aircraft. The key-operated switch mounts from the rear of the panel in a 7/8” dia hole. Available with or without starter position. A-510-2 model with starter position is supplied with switch plate two keys. (diode included). FAA PMA Approved. Made in USA.