Bi-metallic single toggle thermal circuit breakers suitable for homebuilt aircraft. Used as original equipment in Beech, Cessna and Piper aircraft. 0.5 amp to 50 amp ratings may be used as on/off switch. Maximum operating voltages: 32 VDC and 250 VAC (to 400 Hz).

Product Features:

Lightweight, less than 2 oz.

0.5 amp to 50 amp ratings may be used as on/off switch.

Cannot be reset against overload.

Screw termination.

Trip-free operation.

Fine quality switch from ACS used in many aircraft. The switch housing is machined from billet aluminum which makes this switch 25% lighter. It provides “ON” and “OFF” electrical control of both magnetos on a single engine aircraft. The key-operated switch mounts from the rear of the panel in a 7/8” dia hole. Available with or without starter position. A-510-2 model with starter position is supplied with switch plate two keys. (diode included). FAA PMA Approved. Made in USA.

The KLIXON® 7270/7271 series circuit breakers were designed to utilize less behind panel space while protecting wire and cable in aircraft and ground support equipment on either 120 VAC, 400 Hz or 30 VDC systems.

These circuit breakers are available with neck mounting (7270-1 and 7271-8) or standard cover plate (7270-7 and 7271-3). In each of these KLIXON® circuit breakers, the bi-metallic element assures uniform current distribution throughout its responsive area. This design reduces current density at the critical areas, resulting in an element having a much higher interrupting capability than conventional design. Inherently resistant to shock and vibration, the KLIXON® disc element is capable of precise calibration settings and will retain the initial calibration within close tolerances throughout the service life of the breaker. Both circuit breakers have conventional actuator action; i.e., the toggle actuator on the 7270 moves to the OFF position for trip indication and the button the 7271 pops out. A standard black button with a white collar is used. For additional information please refer to the attached documentation.

RED BOX® AVIATION, part of the LPA Group, offers a comprehensive range of aircraft ground power equipment including ground power units, aircraft start power units, aircraft connectors and more.Their ground power range or aircraft GPU, are designed for the civilian and military markets, while the majority of their products are also NATO codified. 

RED BOX® AVIATION aircraft hand portable start power units (packs) are included among the most powerful hand portable packs worldwide. they are based on military aerospace technology to achieve a very high power to weight ratio. These power packs are designed for starting of piston, turboprop or turbine aircraft and helicopters in the field or in remote locations while RED BOX® units may also be carried safely on board all aircraft. The power packs are “all weather” units and being modular, can be used in single or dual format. They can be used or stored in any orientation, even inverted. Cells used are cleared as non-hazardous cargo for carriage in the aircraft. They are able to operate in extremes of temperature and have excellent standby characteristics. They are maintenance free and do not require cycling. They can be re-celled “on condition” at any RED BOX® service center and are designed to offer years of repeated service. In addition to aviation, these highly portable units can be used with Armored Fighting vehicles and Military equipment. They can be recharged from the automatic charging system, which is supplied in the package, or from any vehicle using a suitable interface.

Product Features:

Offered models in different voltages and amperages

Totally weather protected

Air transportable

Non-hazardous

Maintenance Free

Tough and compact

No memory effect

Works in any orientation

High charge retention

Long shelf life

Fast recharge

No cycling

Leak proof

Military Specification MS35058 Series Toggle Switches can be used to upgrade your aircraft's cockpit controls. These heavy-duty metal switches have a standard shape that works well for a variety of applications can be used for most components that only function in either the on or off positions. They are available in several sizes to fit your particular airplane and are shipped with all necessary rings and hardware for installation. Toggle switches are available with two or three operating positions, 1 or 3 hole mounting and a variety of circuitry & electrical ratings. Contacts are made of solid silver. Wide usage is found in aircraft, mobile, marine, electronic and industrial applications. Available in full "AN" standard size & Ultra Miniature 1/2" size, contact types and circuit codes (see reference chart).

High quality vinyl toggle switch covers that do not have a nipple at the end of the cover. Suitable for MS35058 series switches. Available in different colors.

Elevate your aviation experience with Textron Aviation, your trusted source for top-tier aircraft batteries. CONCORDE® BATTERY CORPORATION, is a leader in high-quality lead-acid batteries, to power Cessna®, Beechcraft® and Hawker® aircraft. Their PLATINUM family of batteries offer superior engine starting performance, excellent charge acceptance, reliable essential power in the event of a generator failure, maintenance-free operation with no need for electrolyte or water addition, and advanced absorbed glass mat (AGM) separators.  CONCORDE® PLATINUM batteries are hazmat exempt and shipped fully charged and ready to install.

The  CONCORDE® RG® Series of premium hand made AGM aircraft batteries within the PLATINUM family are low resistance, valve regulated lead acid (VRLA) batteries providing excess power for many applications. The RG-25XC aircraft battery has the highest cranking power and capacity in the 25 Group.

Since its introduction in 1994, the B&C SPECIALITY PRODUCTS BC320 Starter for Continental engines has established an impressive service record as the ONLY starter design on the market that has provided reliable, long-term service for these engines. 

Suitable for installation on Continental engines (C-75, C-85, C-90, C-145-2, O-200, IO-240, O-300-A, -B, and -C, and GO-300-A, -B, and -C) it solves all the problems that other starter designs have had:  worn-out clutches, broken pinions, nagging oil leaks, and catastrophic failure modes. Featuring the durability of all-steel gears and heavy-duty ball-bearings, and the efficiency of a high-torque series-wound motor, it provides greater starting torque, while saving 4.3 to 5.2 lbs. over the old key-type and pull-cable type starters (respectively).

The B&C SPECIALITY PRODUCTS BC320 Starter is STC-PMA approved for use in certificated aircraft, and is available with or without the STC (*). Two installation kits are also available:  one for replacing a key-type starter (Installation Kit 501-1), the other for replacing a pull-cable type starter (Installation Kit 501-3). For key-type starters, before installing the BC320, you will need to remove the needle bearing pressed into the engine case & install the supplied plug in its place. For pull-cable starters, before installing the BC320, you will need to cut off the 9/16 steel shaft that is installed in your engine case.

Other versions of BC320 Starter for 12v and 24v electrical systems (BC320-2, 12v Counter-Rotating or the 24v BC320-3) are also available.

(*) For the issue of the STC, the aircraft make and model, aircraft registration and serial number are required.

The KLIXON® PS series 2 to 35 Amp precision thermal circuit breakers by SENSATA TECHNOLOGIES Inc. (formerly Texas Instruments Sensors & Controls) are designed to interrupt short circuits or overloads and combines trip-free protection with fast response time. They feature a bi-metallic snap-acting disc as the sensing element and they are widely used in production and military aircraft where precise ultimate trip characteristics are required. Models PSM and PSM-N are available in the following ampere ratings 2, 3, 5, 10, 15, 20, 25, 35. When ordering specify if neck-mounting style is wanted by placing “N” after ampere rating. Example: PSM-10N

The KLIXON® PDL series thermal breakers are designed to meet the harshest environmental requirements. They are weatherproof for protection against moisture, dust, grease, fuel vapors, and other harsh environments. For weatherproof circuit breakers in ratings from 50 to 150 amperes, order Model PDLM. 

BC207 High/Low Voltage Warning Indicator by B&C SPECIALITY PRODUCTS  is a solid-state device which provides a visual indication of abnormal bus voltage via a panel-mounted warning light (included). It is intended for use in non certified aircraft. Not FAA Approved. When flashing,the warning light indicates a bus voltage greater than 15.5 volts D.C. When steady, it indicates a bus voltage below 12.5 volts D.C. The product also includes B&C S708-2 Miniature Push-Button switch (push-to-test). The BC207  Voltage Warning Indicator can be used in both 14v and 28v electrical systems. 

ELECTRODELTA is the world market leader in top quality voltage regulators for general aviation aircraft, and continues to revolutionize the industry with proven technologies and improvements. The units are assembled from the highest quality electronic components available and are meticulously tested and calibrated to ensure maximum performance. The ELECTRODELTA product line was acquired in October 2012 by LAMAR TECHNOLOGIES LLC. 

ELECTRODELTA VR Series voltage regulators are offered in 14 and 28 Volt models with FAA/PMA or TSO certifications and are suitable as replacements for use in aircrafts of different manufacturers.

Master Relay (Battery Solenoid) for all homebuilts (not suitable for certified aircraft). Continuous duty. Offered for 12V and 24V systems.

The KLIXON® 7277 series circuit breakers are the commercial grade version of the 7274 series circuit breakers  which are small, lightweight, low amperage devices that are specifically designed to protect aircraft/aerospace cable and components in airborne vehicles and equipment. The KLIXON® 7277 series circuit breakers are physically and electrically identical to the 7274-2 military grade circuit breakers, with the exception that the 7277 series has wider calibration limits.  Klixon® 7277 series breakers have been designed for applications that do not require the tighter performance characteristics and approvals of 7277-2 series military circuit breakers. 

Originally developed as an alternative to slow blow fuses, the trip–free 7277 series breakers are used extensively as primary electrical circuit protection on general aviation aircraft. The wider calibration limits of the 7277 has also resulted in applications including protection for data processing and telecommunications equipment, computers, flight simulators, construction, material handling and other industrial,electronic equipment. Suitable for use on trainer / simulator applications where all breakers are operated on low ampere control current, different ampere rating inserts (amp ratings on top of push button) can be ordered.

KLIXON® 7277 series circuit breakers' features include:

• Miniature size

• Light weight

• Trip–free design

• Current rating: 0.5 to 20 amps

• High vibration resistance

• Options include: dust boot (part #14500-1 fits 15/32 bushing, part #14500-5 fits 7/16 bushing), auxiliary switch, terminal hardware, longer push button.

For additional information please consult the supplied documentation.

These bi-metallic single pole breakers weigh less than 2 oz. and are especially suitable for homebuilt aircraft. Used as original equipment in Beech, Cessna and Piper aircraft. Maximum operating voltages: 32 VDC and 250 VAC (to 400 Hz). 

Product Features:

Lightweight, less than 2 oz.

Push/Pull Actuator Thermal Circuit Breaker

0.5 amp to 50 amp ratings may be used as on/off switch

Cannot be reset against overload

W23 has visible trip indicator

Screw termination

Trip-free operation

Aviation grade ELECTRODELTA X61 series solenoids by LAMAR TECHNOLOGIES LLC are offered in continuous  or intermitant duty in 12 or 24 Volt. They fit current GA production aircraft as well as legacy aircraft and replace both single terminal switched units, as well as the current double terminal switched units in production today. All units have multiple quality and functional tests prior to certification and delivery. Non FAA-PMA Approved.

Product Features:

Replace most contactors in general aviation

Available in 12 or 24 Volt

Available for Continuous or Intermittent duty

All units inspected and tested to performance standards

Warranty 24 months

Versatile split red master switch used in virtually all single engine Cessna models since 1970. It can be used in most light aircraft with single alternator systems. Left rocker normally is used for alternator and right half for battery. Amp Rating: 20. The swich housing mount (P/N: S1843-1) is sold separately and can only be ordered together with the switch.

FAA-PMA Approved original equipment TCM Bendix magneto ignition switches  with 3 positions (Right/Left/Both Mags). They come complete with two keys and faceplate. For dual ignition aircraft systems, ignition switch grounds both magneto P-leads in off position.